eorganize

Coiled length of black two-conductor power cord, bundled with a hook-and-loop strap.

125 ft coil of 6/3 NM-B copper building cable with ground, rated 600V. 6 AWG, three conductors plus ground — sized for 50-amp circuits.

Plastic storage tub holding several cardboard spools of heat-shrink tubing in assorted diameters, plus a large coil of black rubber strip.

Self-adjustable ratcheting ferrule crimping tool with a case of assorted insulated wire-end ferrules (blue, yellow, red, and bare sleeves).

Assorted rolls of colored vinyl electrical tape (blue, green, yellow) for phase marking and insulating.

Roll of black vinyl electrical tape (UL listed) for insulating and bundling wires.

Bin of automotive electrical bits — a 220-piece blade-fuse assortment (mini/standard), assorted loose blade and glass fuses, inline fuse holders/taps, and a 100W load resistor.

A bagged black inline electrical component with red/black leads (marked NT30TFNCE120CB, likely a thermal protector/limiter) shown with a 200-piece fast-blow glass fuse assortment kit (5x20mm and 6x30mm).

Two Qianji JQX-62F 80A high-power relays — one with a 12VDC coil (JQX-62F-2C) and one with an AC110V coil, rated 250VAC/28VDC.

Omron G9EA-1-B high-capacity DC power relay with a 12VDC coil (model G9EA1003H), new in box.

Victron Energy BatteryProtect BP 12/24 100A — a low-voltage battery disconnect that cuts the load to protect a 12/24V battery from over-discharge, with programmable alarm/remote terminals.

Waterproof, ignition-protected 40A resettable circuit breaker with a manual reset button, for 12V DC automotive, marine, and audio systems.

Pair of DIN-rail miniature circuit breakers, model DZ47-63Z, rated C63 (63A) at 250V, ganged together with a lead.

MidNite Solar MNEPV30 30A DIN-rail DC circuit breaker for solar PV systems; polarity sensitive.

Gold aluminum-housed wirewound power resistor rated 100W, 10 ohm — the type used as an LED load resistor or dummy load.

Drawer of crimping and terminal tools — a rivet-nut/riveter tool and crimp pliers — plus assorted crimp and heat-shrink wire connector kits.

Pen-style non-contact voltage detector that lights and beeps near live AC wiring.

Automatic trickle charger/maintainer for 12V lead-acid batteries (model YS-1201250, output 13.8V/1250mA) with alligator-clip leads and a charge status light.

Set of split-core current-transformer (CT) clamps with lead cables and small jack connectors, used with a home energy monitor to sense current on mains conductors.

Item described in a voice note as possibly a fuse holder; no photo available to confirm.

Case of terminal release and pin-extraction tools with assorted tips for depinning automotive and electronic wiring connectors.

Three plug-in WiFi smart outlets, each with a single AC receptacle and a power button, for app or voice control of plugged-in devices.

Round 7-blade (7-way) trailer wiring connector plug with labeled pin terminals for trailer/RV lighting and brakes; includes a mounting bracket/holder.

Plug-in GFCI outlet tester with indicator lights for open ground, open neutral, open hot, reversed wiring, and correct wiring, plus a button to trip and verify GFCI outlets.

Two-piece wire continuity tester with a main unit and a separate remote end, used to trace and verify continuity of wire runs.

Trailer wiring adapter with a round 7-way plug on one end and a blade socket with a flip-up weather cover on the other.

Plug-in electricity usage monitor with an LCD readout for voltage, amperage, wattage, frequency, power factor, and cumulative kilowatt-hours of a plugged-in device.

Plug-in electricity usage monitor with an LCD readout for voltage, amperage, wattage, frequency, power factor, and cumulative kilowatt-hours of a plugged-in device.

Handheld circuit breaker finder transmitter that plugs into an outlet and pairs with a receiver to identify which breaker controls a given circuit.

Assortment of Square D Homeline (HOM) plug-in circuit breakers in mixed amperages from 15A to 50A, both single- and double-pole (DP-4075).

50-foot steel fish tape wound in a round reel case, used to pull wire through conduit and wall cavities.

Handheld locator set with separate transmitter and receiver units; traces buried electrical wiring and non-metallic pipes that carry a conductor or tracer wire. Black zippered hard case with blue trim.

Clear plastic bin of tangled AC power adapters and wall-wart chargers, including 9V and 12V units, plus a battery charger with a digital display.

Assorted small parts in a clear compartment organizer box: electrical wiring and connectors, a rubber sewage/pipe boot, grow-light hardware, and white plastic cable clips and standoffs.

Several gray Schedule 40 PVC electrical conduit sweep elbows — long-radius 90-degree bends used to route conduit around corners.

Bin of plastic/PVC conduit connectors and fittings with boxed Leviton 15A-125V GFCI outlets.

White 6-outlet power strip with a lighted on/off switch and a long grounded cord. Two units.

Coil of gray non-metallic flexible electrical conduit (½ in) and two 2 in rubber pipe couplers with stainless steel band clamps; one coupler still bagged.

Solar MPPT charge controller paired with a small two-button LCD remote display meter on a cable; red and black battery leads attached.

Assorted household light bulbs — LEDs, CFLs, and incandescents in various wattages and bases.

Bin of battery-system wiring, connectors, fuses, and a JQX-62F high-power relay module — leftovers from the battery setup at the previous house.

Bin of thicker, heavy-gauge miscellaneous cables — red, black, and brown — kept for power and high-current runs.

Bin of mid-gauge cables in mixed colors — black, white, red, yellow, green — many partially terminated or bundled with cable ties.

Storage bin holding several multi-outlet surge-protector power strips along with coiled yellow and orange extension cords.

Bin of small, thin miscellaneous wires and short jumper leads — mixed colors, mostly stripped or pre-terminated junk wire kept for ad-hoc repairs.

Box of duct seal — moldable non-hardening putty used to seal electrical, cable, and HVAC penetrations.